Ending my electronic project for geotechnical laboratory !
Today i worked in my university and i finished with an project for geotechnical laboratory. This work was complicated because the sensors used supply my device with the small signal what was masked with the noise! finally, i could find an solution for this problem after two weeks working in this project !
Search from various English teachers...
Corrections · 5
0
The end of my electronic project for the geotechnical laboratory!
Today I worked in my university and I finished a project for the geotechnical laboratory. This work was complicated because the sensors used to supply my device with the small signal (what was masked with the noise - I don't understand this)! Finally, I could find a solution for this problem after two weeks working on this project!
0
hi Amene, nice to meet you! im using the GS4200. Internaly, this sensor have an strength gage with your respective circuitry what produce in the out an voltage proportional to the pressure applied in the sensor (1mV for 10Kpa). The laboratory will use this device to measure water and air pressure in samples of ground(i think it is so!!! im electronical engineer[I will graduate soon], not civil engineer :-D) .....why do you say "it is so frustrating"? can i help you with this? message me if you want !! ;-)
0
What kind of sensors are you using? What do you measure in soil/rock? I'm curious as I've been working on the tactile sensors to measure vertical stress in soil. It's so frustrating!!!
Want to progress faster?
Join this learning community and try out free exercises!
Don’t miss out on the opportunity to learn a language from the comfort of your own home. Browse our selection of experienced language tutors and enroll in your first lesson now!
Start Learning Today
